Safety assessment of the process ‘PEGRA‐V’, based on Starlinger IV+® technology, used to recycle post‐consumer PET into food contact materials
Meta data
Competing interests: In line with EFSA's policy on declarations of interest, Roland Franz did not participate in the development and adoption of this scientific output.
Note: This scientific output is published in accordance with the European Commission decision of4.10.2019 on the confidentiality claims submitted by the applicant (Ref.: C(2019) 7274 final).
Abstract
This scientific opinion of the EFSA Panel on Food Contact Materials, Enzymes, Flavourings and Processing Aids (CEF Panel) deals with the safety evaluation of the recycling process PEGRA‐V (EU register number RECYC0137), which is based on the Starlinger IV+® technology. The input of the process is hot caustic washed and dried poly(ethylene terephthalate) (PET) flakes originating from collected post‐consumer PET containers, containing no more than 5% of PET from non‐food consumer applications. In this technology, washed PET flakes are dried and crystallised in a reactor, then extruded into pellets which are further crystallised in a second reactor. Crystallised pellets are then preheated in a third reactor and fed to the solid‐state polycondensation (SSP) reactor. Having examined the challenge test provided, the Panel concluded that the three steps, drying and crystallisation, extrusion and crystallisation and SSP are the critical steps that determine the decontamination efficiency of the process. The operating parameters that control their performance are well defined and they are the temperature, the gas flow and the residence time for the drying and crystallisation step, and the temperature, the pressure and the residence time for the extrusion and crystallisation step and the SSP step. Under these conditions, it was demonstrated that the recycling process is able to ensure that the level of migration of potential unknown contaminants into food is below a conservatively modelled migration of 0.1 μg/kg food. Therefore, the Panel concluded that the recycled PET obtained from this process intended to be used up to 100% for the manufacture of materials and articles for contact with all types of foodstuffs for long‐term storage at room temperature, with or without hotfill, is not considered of safety concern. Trays made of this recycled PET are not intended to be used, and should not to be used in microwave and conventional ovens.